How to Change AWP Scope Thickness in CS2

Use cl_crosshair_sniper_width to change the thickness of the crosshair lines shown while scoped with a sniper rifle. It changes the visual line width, not the AWP’s zoom level, damage or accuracy.

Change the scoped crosshair step by step

  1. In CS2 settings, enable the Developer Console under Game.
  2. Open the console using its assigned key.
  3. Enter cl_crosshair_sniper_width without a value and note your current setting.
  4. Try cl_crosshair_sniper_width 1 for a thin line or cl_crosshair_sniper_width 3 for a thicker example.
  5. Scope in during a practice session and compare visibility against both light and dark backgrounds.

Which value should you use?

Choose a width that you can see without covering too much of a distant target. A wider line can be easier to notice; a thinner line can leave more of a small target visible. Resolution and display scaling affect the appearance, so a setting copied from another player may look different on your screen.

There is no universally best value or guaranteed accuracy improvement. Keep your other settings stable while comparing. Our private practice guide explains how to create a controlled session, and professional player settings can provide starting points.

What this command does not change

Sniper scope line width is separate from the normal rifle crosshair. It does not add a permanent no-scope crosshair, remove weapon spread, change magnification or make the AWP more accurate. Normal crosshair colour and gap settings should not be assumed to apply to the scope.

Restore or troubleshoot the setting

To undo a change, enter the command followed by the value you recorded earlier. If it resets after restarting, check whether your own autoexec or launch configuration overwrites it. If the console reports an unknown command after a game update, verify the spelling and current command reference before adding more configuration changes.

Reference checked on 6 November 2026: cl_crosshair_sniper_width command examples.

Frequently asked questions

What is the AWP scope thickness command in CS2?

Use cl_crosshair_sniper_width followed by a number, for example cl_crosshair_sniper_width 3.

How do I make the scope lines thinner?

Try a smaller width such as cl_crosshair_sniper_width 1, then compare it in a practice session.

How do I make the scope lines thicker?

Try a larger width such as cl_crosshair_sniper_width 3 and check that it does not obscure distant targets.

Does this change AWP zoom?

No. The command changes scoped crosshair line width, not magnification.

Does a thicker scope improve accuracy?

It does not alter weapon accuracy. It may make the lines easier to see, depending on your display and preferences.

Will rifle crosshair settings change the sniper scope?

The normal rifle crosshair and sniper scope have separate settings. Do not assume colour or gap settings transfer to the scope.

How do I restore my previous scope width?

Record the current value before editing, then enter cl_crosshair_sniper_width followed by that original value.

Why does my scope width reset?

A personal config or autoexec may overwrite it. Check your saved configuration before changing additional settings.

You need to accept marketing consents
Invalid email address.
Added successfully.